Beaded Netted Star Pattern By Jen Lawson

Welcome to the beaded netted star pattern instructions! This pattern was generously created and donated to all of us by our fellow beader Jen Lawson. If you have any difficulty following this tutorial, please post a comment at the bottom of the page, and I'll do my best to help, or if I am unable, I will inform Jen Lawson of the difficulty.
Jen has been a regular contributor, with many items on the beading market and on her own website, at Jen's Beadwork Website, where Jen sells many of her own creations for very reasonable prices.


The beaded netted star by Jen Lawson

Before you begin ...
4mm crystals, or other beads
Size 10/0 seed beads
Stopper bead, any color, will be removed later.
Fine fishing line, approximately 80cm
Beading needle, or other fine needle
Time required: 30 minutes
Techniques: Beadweaving, netting
Difficulty: Very easy

Step 1

Step 1:
a) Thread the fishing line onto the needle
b) Tie on a stopper bead. A stopper bead is a bead the same size or smaller than the smallest bead you are using. String through it twice to hold it in place.
c) Add 6 seed beads, 1 crystal and 1 seed bead.
d) Go back through the crystal, and pull tight.
e) String on another 6 seed beads, a crystal, and this time 4 seed beads.
f) Go back through the first seed bead you strung on, through the same way you came from originally. Then back through the crystal.

Step 2

Step 2:
a) Continue in this manner, adding 6 seed beads between each section, crystals next to each end, and ends alternating between a single seed bead, and a 4 seed bead circle.
b) This should form a zigzag pattern with the 4 bead circles on one end, and the single beads on the other, as in the diagram.
c) Stop when you have 6 of each types of ends. 12 points all together.

Step 3

Step 3:
a) The thread should now be coming out of the crystal, in readiness for the 6 seed bead centre. Now instead of starting a new 6 bead section, just string back through the first section, all the way through the first 6 seed beads, the crystal, and the end seed bead.
b) You should now have a rough circle. String through the next single seed bead, at the next point, then the next. Continue through them all. Then go through them all again.

Step 4

Step 4: Tie off, and thread through a few beads. Remove stopper bead, tie, and thread through a few beads.

  Beader Comments:
There are currently no comments for this page. Add your comment today!